Nikon D7000, Manual Mode


Probably one of the most advanced, and yet most basic, skills to master is shooting in Manual mode. With the power and utility of most of the automatic modes, Manual mode almost never sees the light of day. I have to admit that I don’t use it very often, but there are times when no other mode will do. One of the situations that works well with Manual is studio work with external flashes. I know that when I work with studio lights, my exposure will not change, so I use Manual to eliminate any automatic changes that might happen from shooting in Program, Shutter Priority, or Aperture Priority mode.

This image (Figure 11.4) was taken in my home studio using a simple portable shooting table and two external flashes. One flash was used underneath the transparent table and the other flash was used with a small soft box. Manual mode allowed me to avoid changes in my setup.

Since I knew the light was a constant, it allowed me to take the time to make adjustments manually to expose the image exactly how I wanted it. Manual mode gives you ultimate creative control.

I used manual mode
Figure 11.4 These tulips provided a nice subject for a studio still life. In order to expose the flowers correctly and get the look I wanted, I used manual mode.

Bulb photography

If you want to work with long shutter speeds that don’t quite fit into one of the selectable shutter speeds, you can choose Bulb. This setting is only available in Manual mode, and its sole purpose is to open the shutter at your command and then close it again when you decide to. I can think of several scenarios where this would come in handy: shooting fireworks, shooting lightning, capturing the movement of the stars at night, and any other very long exposure.

If you are photographing fireworks, you could certainly use one of the longer shutter speeds available in Shutter Priority mode, since they are available for exposure times up to 30 seconds. That is fine, but sometimes you don’t need 30 seconds’ worth of exposure and sometimes you need more.

If you open the shutter and then see a great burst of fireworks, you might decide that that is all you want for that particular frame, so you click the button to end the exposure. Set the camera to 30 seconds and you might get too many bursts, but if you shorten it to 10 seconds you might not get the one you want (Figure 11.5).

image I had in mind
Figure 11.5 It took me several attempts to get this exposure right, but using my Bulb setting allowed me to capture the image I had in mind.

To select the Bulb setting, simply place your camera in Manual mode, press the shutter release halfway to activate metering, and then rotate the Command dial to the left until the shutter speed displays Bulb on the control panel.

When you’re using the Bulb setting, the shutter will only stay open while you are holding down the shutter button. You should also be using a sturdy tripod or shooting surface to eliminate any self-induced vibration while using the Bulb setting. Pressing the shutter button down opens the shutter, and releasing it closes the shutter.

I want to point out that using your finger on the shutter button for a bulb exposure will definitely increase the chances of getting some camera shake in your images. To get the most benefit from Bulb, I suggest using a remote cord such as the Nikon MC-DC2 Remote Switch or the Nikon ML-L3 Wireless Remote.